The Clarius Fan is a lightweight device that mounts externally to a Clarius 1st generation scanner to reduce heating and extend the scanning time to a maximum of 60 minutes of continuous scanning (depending on the workflow, imaging mode, and performance setting). Once the fan is attached to the scanner, it will automatically turn on once the scanner reaches a certain threshold, and turn off when the scanner is again close to room temperature.
- Align the top notch of the fan to sit on the scanner's 3rd groove from the top.
Note: Always install the fan from the long side, as installing it from the shorter side may cause damage to the contact pins.
- Snap the fan in place. The contact pins on the fan should align with the contact pins of the scanner.
- To remove the fan, detach the fan from the shorter side.